Radio controlled clock manual

These instructions will work on all Atomic Clocks that have the four gray time zone buttons. A radio – controlled clock is a clock with an internal radio receiver that is permanently tuned to receive a special time signal transmitted by the National Institute of Standards and Technology (NIST) radio station WWVB, located in Fort Collins, Colorado. The WWVB transmitter is linked to a cesium atomic clock , . RADIO CONTROLLED ANALOG CLOCK. Quick set up instructions.

Welcome to the world of atomic timekeeping technology.

We hope you will enjoy the convenience of never having to set your clock again and the confidence of knowing exactly what time it is. Twist and lift open the battery. Watch this movie and hopefully this will help you to solve. It can receive the time signal transmitted by Physikalisch-Technische Bundesanstalt ( PTB) of Germany, which is regulated by atomic clocks and in average deviates less . We shall not be liable for any damage occurring as a result of not following these instructions. Please take particular note of the safety advice!

Please look after this manual for future reference. Change location (interference!) Wait for attempted reception during the night. If someone asks you for the time, he’s not expecting an answer that is correct down to the very millisecond.

Press the RESET button with a pin. Radio controlled wall clock. Ensure that the battery polarity is correct. The RC Clock will automatically start scanning for the radio controlled. As soon as the transmitter is received again, the clock will automatically synchronize with the received time.

In case of mal-function after insert of battery, use a pin to press the RESET key to restart the clock. Install two new AAA size batteries as per the polarity information marked on the battery compartment. Replace the battery door. Once the battery is installe the normal segments of the LCD will be shown before entering the radio controlled time reception mode. The radio controlled clock will.

On rare occasions in certain areas, the clock may not be able to receive the radio controlled function because of the strength of the signal or the geographic location. In this case, the clock can be set manually and used as a regular quartz wall clock. Note: Allow up to five nights for the clock to receive the WWVB signal before. OPERATING INSTRUCTIONS : Step 1: Verify hands are exactly at the 12:position. If hands have moved during shipping see “Positioning Hands”.

Step 2: Move the slide switch on the movement to match your local time zone.

Integrated radio receiver for reception of time signal. Signal Reception: Every hours. Toggles between displaying ambient temperature in °F and °C. Used to manually set the clock.

Displays the time-of-day alarm time. Remove the battery door by slightly pressing the knob upward. Insert one new AA size battery as per indication marked in the battery compartment.

When the battery is inserte all the segments of the display. Precision, London Clock Co,LCC, Seiko. TEMPERATURE AND MOON PHASE. FEATURES: ATOMIC CLOCK : Function buttons. Press and hold “SET” key for seconds until HOUR digit .